penumatic

  1. Physical fundamentals of pneumatics
  2. Function and application of pneumatic components
  3. Designation and drawing of pneumatic symbols
  4. Representation of motion sequences and switching statues
  5. Drawing pneumatic circuit diagrams in accordance with standards
  6. Direct and indirect stroke-dependent control systems
  7. Logical AND/OR function of input signals
  8. Time-dependent control systems with time delay valve
  9. Pressure-dependent control systems with pressure sequence valves
  10. Fault finding in simple pneumatic control systems
  11. Safety Regulations
  12.  
  13. - Function and application of pneumatic components
  14. -Stroke-dependent control systems with different sensors
  15. -Control system with start and setting-up conditions (Automatic , Manual , Single Cycle/Continuous Cycle ,Manual step mode , stop at end of cycle)
  16. -Control system with vacuum components
  17. -Step diagram control system/process-controlled sequence controls
  18. -Program control systems with stepper
  19. -Control systems with safety conditions(Emergency-Stop/Emergency-Stop reset)
  20. -Program control system with stepper modules (Quick stepper)
  21. -Pneumatic counting , storing, adding
  22. -Resetting of components (e.g. back pressure valve, proximity switch)
  23. -Time-program control/Time-oriented sequential control
  24. -Fault finding in extensive pneumatic control systems
  25. -Safety regulations


 
Label